Looking for Answers about samsung DV431AGP/XAA?

Samsung part number is LPKIT-3.

The kit is installed into the gas valve of the dryer, which is located behind the front panel. Two parts are removed from the valve and replaced with the corresponding parts from the kit.

Thanks for the question. Please refer to the Cycle Chart on page 37 of the user manual for details of which settings are available for which cycles. While the Medium-Low option is available only in the Time Dry mode, there are Sensor Dry modes that would allow for either Medium or Low to be selected. The manual can be downloaded as a pdf file from this website for easy reference.

- Ms. Samsung

1) Remove the top by taking out the two screws at the rear of the unit.
2) Remove the control panel by taking out the four (?) screws going into the sheet metal behind it.
3) Disconnect the control panel and put aside.
4) Remove the two screws from the front panel in the middle in front of the lint screen.
5) Push down on the two spring clips at the top of the unit behind the chrome trim (they were under the control panel). You don't have to remove the trim.

That should be it and the panel should come forward. You'll need to disconect the wire to the light also.

Please try turning the signal down or off using the Signal button on the control panel, and turn the Mixed Load Bell off by pressing the Mixed Load Bell button. If the buzzing continues, please call 800-SAMSUNG to speak with an agent who will be happy to assist you further.

Thank you,
Ms. Samsung